Product ID:PHILLYCLAD 1015 HAZE GRAY RESIN
MSDS Date:09/23/1987
FSC:8010
NIIN:00N024574
MSDS Number: BMGBX

ITW/PHILADELPHIA RESINS CORP

130 COMMERCE DR
MONTGOMERYVILLE, PA 18936
US

Emergency Phone: 215-855-8450

Info Phone: 215-855-8450

Cage: IO157

ITW/PHILADELPHIA RESINS CORP

MONTGOMERYVILLE, PA 18936 US

Telephone: 215-855-8450

Cage: IO157

TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293

6.

CAS: 1330-20-7

RTECS: ZE2100000

OSHA PEL 100 PPM;150 STEL

ACGIH TLV: 100 PPM;150 STEL

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

2-PROPANOL,1-METHOXY-;(PROPYLENE GLYCOL MONOMETHYL ETHER).

CAS: 107-98-2

RTECS: UB7700000

OSHA PEL 100 PPM;150 STEL

ACGIH TLV: 100 PPM;150 STEL

3.

CAS: 64741-68-0

1%.

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:IRRIT OF EYES & SKIN MAY OCCUR
W/EXPOS. CONTINUED BREATHING OF VAPORS MAY IRRIT RESP TRACT CAUSING
HDCH, NAUS, DIZZ &/OR NARCOSIS WHICH IS TYPICAL FOR SOLV BASE
PRODUCTS. PRLNGD/RPTD CONTACT MAY CAUSE SKIN SENSIT OF SUSCEPTABLE
INDIVIDUALS. CHRONIC:PRLNGD/RPTD EXPOS TO POLYAMIDE RESINS MAY
CAUSE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:ASTHMA & SKIN SENSIT OR OTHER ALLERGIC
RESPONSES. OVEREXPOSURE TO SOLVENTS ABOVE THEIR TLV'S MAY CAUSE
LIVER & KIDNEY DISORDERS. SIGNS/SYMPS:MAY CAUSE IRRITATION OF
EYE/SKIN. SKIN CONTACT MAY CAUSE DEFAT, LEADING TO IRRIT.
EXCESSIVE INHAL MAY CAUSE HDCH, DIZZ, IRRITATION TO RESPIRATORY
TRACT AND/OR NAUSEA.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL:MOVE TO FRESH AIR. RESTORE RESP IF NEC. TREAT
SYMPTOMATICALLY. EYE:FLUSH IMMED W/COPIOUS AMTS OF WATER FOR AT
LEAST 15 MINS, WHILE HOLDING EYELIDS OPEN. CALL MD. SKIN:WASH
W/SOAP & WATER. REMOVE CONTAM CLTHG. CALL MD IF IRRIT PERSISTS.
INGEST:DRINK 1/2 GLASSES OF WATER TO DILUTE. IF SPONTANEOUS VOMIT
OCCURS, KEEP HEAT AT/BELOW KNEE LEVEL TO PVNT ASPIR INTO LUNGS.
CALL MD/POS CTL CTR IMMED.

Flash Point Method:TCC
Flash Point:80.0F,26.7C
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL, WATER MIST.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED SCBA & FULL PROT
EQUIP . SMOTHER FLAMES WITH EXTINGUISHING MEDIAL. WATER MAY BE USED
TO COOL DOWN UNOPENED CONTAINERS IN VICIN.
Unusual Fire/Explosion Hazard:CONTAINS FLAMMABLE SOLVENT. DO NOT USE IN
AREA WHERE SPARKS OR OPEN FLAMES ARE PRESENT.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. WEAR
APPROPRIATE PERS PROT EQUIP WITH NIOSH/MSHA APPROVED RESPIRATOR.
CONTAIN SPILL WITH ABSORBANT MATERIAL & PUT INTO VAP TIGHT CNTNRS.
PVNT MATL FROM ENTERING ANY WAT ER SOURCES OR SEWERS LEADING TO
SURFACEWATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN AREAS DESIGNED TO COMPLY WITH
ANSI/NFPA 30 FLAMMABLE AND COMBUSTIBLE LIQUIDS CODE.
Other Precautions:DO NOT HANDLE UNTIL MANUFACTURERS SAFETY PRECAUTIONS
HAVE BEEN READ & UNDERSTOOD. PROVIDE ADEQUATE VENTILATION OR
RESPIRATORY PROTECTION TO REMOVE DECOMPOSITION PRODUCTS DURING
WELDING OR FLAME CUTTIN G COATED SURFACES.

Respiratory Protection:ALL RESPS MUST BE NIOSH/MSHA APPRVD. IN
OUTDOOR/OPEN AREAS, USE APPRVD RESP TO REMOVE SOLID AIRBORNE
PARTICLES OF OVER SPRAY DURING SPRAY APPLIC. IN RESTRICTED VENT
AREAS, USE APPRVD RESP DESIGNED TO REMOVE COMBINATION OF
PARTICULATES/VAP.
Ventilation:SUFFICIENT VENTILATION IN VOL & PATTERN SHOULD BE PROVIDED
TO KEEP AIR CONTAMINANT CONC BELOW CURRENT APPLIC OSHA PEL.
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:NONE SPECIFIED BY MANUFACTURER.
Work Hygienic Practices:PREVENT PROLONGED SKIN CONTACT WITH
CONTAMINATED CLOTHING. WASH HANDS BEFORE EATING, SMOKING, OR USING
WASHROOM.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Boiling Pt:B.P. Text:248F,120C
Vapor Density:HVR/AIR
Spec Gravity:1.25
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NIL
Appearance and Odor:GRAY COLORED LIQUID, AROMATIC ODOR
Percent Volatiles by Volume:52.2

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS, STRONG ACIDS AND BASES.
Stability Condition to Avoid:EXTREME HEAT, SPARK OR FLAME.
Hazardous Decomposition Products:MAY FORM CO*2 AND NO*X.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.